The preparation of blood and the production of components from it are carried out in accordance with from "Instructions for the procurement and preservation of blood, approved by the M3 RF on 29.05.1999.
1. Place the container to collect blood and set a zero.
2. Hang the blood collection container below the donor's hand so that the distance between the container and the donor's arm is at least 60 cm.
3. Apply a cuff to measure blood pressure or a tourniquet. Disinfect the venipuncture site. Inflate the cuff to 60 mm Hg. Art. Form a free node) on the donor tube about 10 cm from the needle.
4. Take the donor tube to the clamp.
5. Remove the protective cap from the needle and hold the venipuncture.
6. Loosen the compression cuff, and remove the clamp to begin taking the blood.
7. Stir blood and hemoconvant periodically throughout the blood sampling.
8. Collect blood by weight according to the table.
9. After completing the blood collection, tighten the previously applied knot and remove the needle from the donor's hand.
10. After collecting blood, immediately mix blood with hemoconvant by turning the container several times.
11. Squeeze blood from the donor tube into the container.Shuffle and re-fill donor tube with blood with gemokonservantom.
12. Using a sealer or aluminum rings, seal the donor tube with the numbers. Start sealing the donor tube from the side of the needle, and then from the side of the container.
13. Store the filled container with blood at a temperature of 1-6 ° C.