2. Put the air in the syringe in the volume corresponding to the required dose of insulin. Insert air into the vial with insulin.
3. Turn the bottle with the syringe upside down and type the desired dose of insulin into the syringe. Remove the needle from the vial and remove air from the syringe. Check the correctness of the dose of insulin.
4. Immediately inject.
The technique of injection with the use of insulin in cartridges
Cartridge with Humodar® K25 100 Rec is intended for use only in syringe pens. Care should be taken to follow the instructions in the instructions for using the syringe pen for insulin administration.
Before using, make sure that there are no damages (for example, cracks) on the cartridge with Humodar® K25 100 Rivers. Do not use the cartridge if there are any visible damage. After the cartridge is inserted into the syringe pen, a colored strip should be visible through the cartridge holder window.
Before placing the cartridge in the syringe pen, turn the cartridge up and down so that the glass ball moves from end to end of the cartridge. This procedure should be repeated at least 10 times, until all the liquid becomes white and evenly turbid.Immediately after this, an injection must be made.
If the cartridge is already inside the pen syringe, turn it with the cartridge inside up and down at least 10 times. This procedure must be repeated before each injection.
After the injection, the needle should remain under the skin for a minimum of 6 seconds. Keep the button depressed until the needle is completely removed from the skin, thus ensuring the correct dose administration and limiting the possibility of blood or lymph flow into the needle or the insulin cartridge.
Cartridge with Humodar® K25 100 Rec is intended only for andndividuse and is not subject to re-filling.
Injection procedure
- Before the introduction of insulin, disinfect the injection site.
- With two fingers, assemble the skin fold, insert the needle into the base of the fold at an angle of about 45 ° and insert insulin under the skin.
- After the injection, the needle should remain under the skin for at least 6 seconds, in order to ensure that the insulin is injected completely.
- If, after removing the needle, blood appears on the site of the injection, gently press the injection site with a swab moistened with a disinfectant solution (for example, alcohol).
- It is necessary to change the injection site.